Should I install wet rooms to my new home in the West London

In the past 10 years, wet rooms have become very fashionable across Europe, with an increasing number of people switching from conventional baths or cabinets. In this article, we analyze the advantages and disadvantages of a wet room and consider the different design aspects.

Top advantages

The benefits of a well-installed wet room are: -

Level access - No steps up or down the shower tray, but a gradual path from the edge of the shower area to the waste position has created.

Tanked room - The entire floor space (with a 100mm turn-up on the wall) plus full wall height tanked (waterproofed); with an approved waterproofing system in the immediate shower space. Only the tray itself is waterproof, with a conventional shower tray, and water often tracks the edges of the tray to leak into the area below.

Drainage system - The waste disposal is in a wet room at the lower point in the room, and there is an adhesive system for waterproofing sealing. This trap can remove from above, which means that it can be kept without disturbing tiling or any other finish in case of a block.

Aesthetics – The reason people choose wet rooms is probably the only reason they look. Designs of the wet room are usually very uncluttered. The floor finish needs to select, including the wet shower area. Every screen included is usually straightforward and minimalist, usually with a milled glass edge and very little metal or plastic frames and trim.

Some dark sides may happen, too!

Splash - The water does not splash over the shower area while showering. The shower area does not fully enclose. It is fine from an insulation point of view; because the whole room has filled. But if you are not used to that, it can be annoying. They get wet if you leave towels or clothing lying on the floor. The seat might wet if you have a toilet near the shower. This is not a question if you have a big room, but I would encourage you to use a shower screen to remove the worst splashes from smaller wet rooms. You will probably want to pull excess water back into the shower area after showering.

This is part of the wet room routine, but if you irritate by the wet floor; go for a traditional shower bath or create a wet room with a more traditional glass surrounding. Floor heating, which will drain out stray water droplets quite quickly, can also significantly improve the situation in the process.

Cost – The cost of installing a Wet room can be more money than a conventional bathroom depending on the location and type of building. The floor must be "falling to fall" in the shower area; to bring water down to the waste outlet. This slope can build on a concrete surface on the floor, but a former shower tank is usually used on a joisted wooden floor. A former shower tray has an incline to falls. It just fixes on the cartridges, washed, and then tiled. Most companies have several "off the shelter" sizes; which are fairly cheap, but the cost will almost certainly be m if you need an appropriate solution.

An approved waterproofing kit has also needed in addition to a former shower tray. The prices have normally quite reasonably low, although the cost can vary greatly depending on your position. If you have to pay an allowed installer and in all cases are an additional cost over; above conventional installation for a shower.

Wet rooms at the Royal Bathrooms

Removing a bath and replacing it with a wetroom in the UK is quite common. This can act as a practical improvement in the home, but it should always be carefully considered; as removing the only bath in a family home would devalue the property or make it difficult to sell, whereas it will have a positive effect in a studio. Google now!